JPPlus 10oz Stainless Steel Lowball Tumbler (SSL10) template size
The print area of the JPPlus 10oz Stainless Steel Lowball Tumbler (SSL10) is straight (a plain rectangle). Here are its measurements, a free true-size template, and a one-click way to warp your design for it.
| Print area | Top circumference | Bottom circumference | Height |
|---|---|---|---|
| Whole wrap | 10.996 in (279 mm) | 10.996 in (279 mm) | 3.54 in (90 mm) |
From the published source below; not yet confirmed by TaperWrap users.
Open this cup in TaperWrap Download blank SVG
Note: Circumference is π × 3.5 in. JPPlus's print area is 10.89 in, about 3 mm short of a full wrap.
Flat template: 11 × 3.54 in (279 × 90 mm), without seam overlap.
Check your own cup
Cups sold under the same name can differ by a few millimetres, and that shows up as a gap at the seam. Measure the top and bottom circumference of the print area with a soft tape and compare (how to measure).
Measured yours? Open it in TaperWrap and download your wrap; afterwards TaperWrap asks whether these numbers fit your cup. Confirmations and corrections from crafters keep this page accurate. Only the numbers are shared, never your design.
Sources
- jpp.trgcdn.com (supplier template: "DIMENSIONS: 10.89" x 3.54""; product "4.5" x 3.5" wide")
Similar blanks
- 20 oz skinny straight tumbler (common template)
- MakerFlo 20 oz skinny straight tumbler
- Conde LumaSteel Stainless Steel Skinny Tumbler 20oz (TUM217 white / TUM218 clear gloss)
- Conde LumaSteel Sippy Cup 13oz SSCUP13S
- Conde LumaSteel Stainless Steel Sublimation Water Bottle 32oz WB014
- Conde DyeTrans Ceramic Shot Glass 3oz SHOT04
See every cup in the Blank Registry.