MakerFlo 18oz Hydro Water Bottle template size
The print area of the MakerFlo 18oz Hydro Water Bottle is straight (a plain rectangle). Here are its measurements, a free true-size template, and a one-click way to warp your design for it.
| Print area | Top circumference | Bottom circumference | Height |
|---|---|---|---|
| Whole wrap | 9.299 in (236 mm) | 9.299 in (236 mm) | 7.1 in (180 mm) |
From the published source below; not yet confirmed by TaperWrap users.
Open this cup in TaperWrap Download blank SVG
Note: Circumference is π × 2.96 in. MakerFlo's template is 9.55 × 7.1 in (about 0.25 in overlap).
Flat template: 9.3 × 7.1 in (236 × 180 mm), without seam overlap.
Check your own cup
Cups sold under the same name can differ by a few millimetres, and that shows up as a gap at the seam. Measure the top and bottom circumference of the print area with a soft tape and compare (how to measure).
Measured yours? Open it in TaperWrap and download your wrap; afterwards TaperWrap asks whether these numbers fit your cup. Confirmations and corrections from crafters keep this page accurate. Only the numbers are shared, never your design.
Sources
- makerflo.com (supplier template: 18oz Hydro Bottle | 9.55 x 7.1; straight; 9.19" H x 2.96" D)
Similar blanks
- 20 oz skinny straight tumbler (common template)
- MakerFlo 20 oz skinny straight tumbler
- Conde LumaSteel Stainless Steel Skinny Tumbler 20oz (TUM217 white / TUM218 clear gloss)
- Conde LumaSteel Sippy Cup 13oz SSCUP13S
- Conde LumaSteel Stainless Steel Sublimation Water Bottle 32oz WB014
- Conde DyeTrans Ceramic Shot Glass 3oz SHOT04
See every cup in the Blank Registry.