JPPlus 12oz Skinny Can Cooler (SSCK) template size
The print area of the JPPlus 12oz Skinny Can Cooler (SSCK) is straight (a plain rectangle). Here are its measurements, a free true-size template, and a one-click way to warp your design for it.
| Print area | Top circumference | Bottom circumference | Height |
|---|---|---|---|
| Whole wrap | 8.796 in (223 mm) | 8.796 in (223 mm) | 5.94 in (151 mm) |
From the published source below; not yet confirmed by TaperWrap users.
Open this cup in TaperWrap Download blank SVG
Note: Circumference is π × 2.80 in. JPPlus's template is 9.06 in wide (about 0.25 in overlap).
Flat template: 8.8 × 5.94 in (223 × 151 mm), without seam overlap.
Check your own cup
Cups sold under the same name can differ by a few millimetres, and that shows up as a gap at the seam. Measure the top and bottom circumference of the print area with a soft tape and compare (how to measure).
Measured yours? Open it in TaperWrap and download your wrap; afterwards TaperWrap asks whether these numbers fit your cup. Confirmations and corrections from crafters keep this page accurate. Only the numbers are shared, never your design.
Sources
- jpp.trgcdn.com (supplier template: Template "9.06" x 5.94""; product "2.80" x 2.80" x 6.10"")
Similar blanks
- Polar Camel Slim Can Beverage Holder
- Polar Camel Standard Can Beverage Holder
- Heat Press Nation SubliCraft SubliCraft Stainless Steel Can Cooler for Skinny 12 oz Cans
- Heat Press Nation SubliCraft SubliCraft Stainless Steel Can Cooler for Standard 12 oz Cans
- HTVRONT Sublimation Clear/Frosted Glass Can with Bamboo Lid 16oz
- MakerFlo 12oz Slim Duozie can cooler
See every cup in the Blank Registry.