JPPlus 12oz Stainless Steel Classic Can Cooler (DWC12) template size
The print area of the JPPlus 12oz Stainless Steel Classic Can Cooler (DWC12) is straight (a plain rectangle). Here are its measurements, a free true-size template, and a one-click way to warp your design for it.
| Print area | Top circumference | Bottom circumference | Height |
|---|---|---|---|
| Whole wrap | 10.03 in (255 mm) | 10.03 in (255 mm) | 4.49 in (114 mm) |
From the published source below; not yet confirmed by TaperWrap users.
Open this cup in TaperWrap Download blank SVG
Note: Published print-area width; no diameter published.
Flat template: 10.03 × 4.49 in (255 × 114 mm), without seam overlap.
Check your own cup
Cups sold under the same name can differ by a few millimetres, and that shows up as a gap at the seam. Measure the top and bottom circumference of the print area with a soft tape and compare (how to measure).
Measured yours? Open it in TaperWrap and download your wrap; afterwards TaperWrap asks whether these numbers fit your cup. Confirmations and corrections from crafters keep this page accurate. Only the numbers are shared, never your design.
Sources
- jpp.trgcdn.com (supplier template: "DIMENSIONS: 10.03" x 4.49"")
Similar blanks
- Polar Camel Slim Can Beverage Holder
- Polar Camel Standard Can Beverage Holder
- Heat Press Nation SubliCraft SubliCraft Stainless Steel Can Cooler for Skinny 12 oz Cans
- Heat Press Nation SubliCraft SubliCraft Stainless Steel Can Cooler for Standard 12 oz Cans
- HTVRONT Sublimation Clear/Frosted Glass Can with Bamboo Lid 16oz
- MakerFlo 12oz Slim Duozie can cooler
See every cup in the Blank Registry.