JPPlus 40 oz tumbler with handle (Stanley-style) template size
The print area of the JPPlus 40 oz tumbler with handle (Stanley-style) is printed in 2 sections. Here are its measurements, a free true-size template, and a one-click way to warp your design for it.
| Section | Top circumference | Bottom circumference | Height |
|---|---|---|---|
| Section 1 (top) | 12.375 in (314 mm) | 12.375 in (314 mm) | 5.5 in (140 mm) |
| Section 2 | 9.313 in (237 mm) | 9.313 in (237 mm) | 3 in (76 mm) |
From the published source below; not yet confirmed by TaperWrap users.
Open this cup in TaperWrap Download blank SVG
Flat template: 12.38 × 8.7 in (314 × 221 mm), both pieces stacked, without seam overlap.
The plain band between the sections isn't published. Measure it on your cup and enter it in TaperWrap under Section 2 so your design lines up across both pieces.
Check your own cup
Cups sold under the same name can differ by a few millimetres, and that shows up as a gap at the seam. Measure the top and bottom circumference of the print area with a soft tape and compare (how to measure).
Measured yours? Open it in TaperWrap and download your wrap; afterwards TaperWrap asks whether these numbers fit your cup. Confirmations and corrections from crafters keep this page accurate. Only the numbers are shared, never your design.
Sources
- jpplus.com (supplier template: DW40SH-W official template: top 12.375 × 5.5 in, bottom 9.313 × 3 in)
Similar blanks
See every cup in the Blank Registry.